If you are looking for algeria aluminium disc supplier, here we can be your trustworthy aluminum circle factory. In recent years, with the development of the economy, various high-tech industries are also advancing with leaps and bounds. Many alloy plate and strip products, led by aluminum discs, are gradually being used in all walks of life. Haomei Aluminum's aluminum disc production line is self-coiling, no manual contact with any work materials is required until the entire roll of material is completely blanked. There is no need to carry out the slitting and cross-cutting of the coil material, which reduces the production process, reduces the production cost, and reduces the possibility of damaging the surface of the coil material. By using modular mold design, when converting aluminium disc production specifications, the conversion time can be effectively reduced. The aluminum discs production speed can reach 20-60 pieces per minute, which improves production efficiency.
When producing algeria aluminium disc, Haomei Aluminum always add a protective film or put a piece of paper to protect the surface of the aluminum discs from damage. The hardness of aluminum is much softer than that of other metals. As long as the surface is rubbed slightly, there will be many small scratches on the surface. So when we are transporting aluminium disc to Algeria customers, we must be very careful, mainly to protect the surface of the aluminum discs to avoid scratches.
Usually, in order to prevent the surface of the algeria aluminium disc from being scratched, it will be protected by a protective film or separated by paper when it is long, so as to avoid scratches caused by the friction between the aluminum disc and the aluminum disc. At the same time, it must be ensured that it is relatively firm during transportation, so as to avoid the problem of sliding due to transportation, which is more likely to cause scratches. In addition, workers need to wear gloves when carrying them manually, which can prevent sweat from remaining on the surface of the aluminum disc, because the surface of the aluminum disc is likely to be corroded or oxidized over time. When processing, especially when shearing and bending, it is recommended to stick a protective film if the surface quality requirement is higher.